Finn HydroSeeder T170 SSA, Руководство по эксплуатации и каталог запасных частей

Страница: 26 / 80

TROUBLE SHOOTING YOUR HydroSeeder
®
:
Problem Probable Causes Suggested Solutions
LEAKS:
Tank bearing leaks. Lack of lubrication - Replace seal and follow lube
seal worn. schedule.
Bolts not tightened. Tighten uniformly to 25 ft. lbs.
properly.
Pressure Clamps. Rubber seal cracked, Replace, always grease seal
pinched or torn. before clamping shut.
Suction. Rubber seal cracked, Replace, always grease seal
pinched or torn. before clamping shut.
Discharge Swivels. Not greased often enough. Rebuild swivels w/repair kit (part
#12397, 2 required).
Pump Shaft. Pressure lubricator not Replace pump seal, service
serviced. pressure lubricator daily.
Pump Suction Cover O-Ring bad. Replace cover O-Ring, use grease
Cover. when replacing.
Discharge Boom Worn or no gasket. Replace gasket.
or Nozzle Camlock
Fittings.
MACHINE JUMPS DURING OPERATION:
Agitator. Agitator bent by heavy Straighten agitator or shim, so it
object falling on it. runs true.
Bent Paddles. Loading wood fiber mulch Straighten agitator paddle, realign
into tank before tank is agitator to run true.
half full.
FOAMING OF SOLUTION AND LACK OF DISTANCE:
Pump looses prime - Sucking air in suction Check all suction connections to see
lacks distance - leaves lines. that rubber seals are in good shape.
excessive amount in Grease seals before replacing clamps.
tank (100 gal (378 liters)
or more).
Air entrainment. See page 20.
Low engine RPM. Check throttle cable and linkage,
(Below 2750 RPM-No load) See authorized engine dealer.
Soft water. Slow the agitator.
Too much agitation. Slow the agitator.
Pump worn. Reset pump tolerance page 30.
Suction partially plugged. Clean out machine see page 24.
Nozzle worn or plugged. Clean nozzles, replace if necessary.
Fertilizer. Change type.
Clutch slippage. Readjust clutch page 34.
VALVE:
Valve stuck. Frozen. Thaw out ice, lubricate. Leave in
discharge position during storage.
22