FINELITE
INSTRUCTIONS
1. Position fixture on wall in desired location.
Mark on wall the point where the endcap
and the fixture body meet. This is Point A.
Remove fixture.
2. Determine feed location by measuring a
horizontal line 4.5
″
from Point A toward
center of fixture, then 1.75
″
downward.
Mark this spot for feed.
3. Install 4
″
x2
″
J-Box centering box over feed
location and align top of box with Point A.
Leave 8-10
″
of power wire exposed.
4a. Measure a horizontal line from Point A to
the opposite end of the fixture (or run) and
mark the wall at the center of each stud and
at the end of the fixture (or run). This marks
the top of the fixture (or run).
4b. At each support location that is not secured
into a stud (usually ends) drill hole 1.25
″
down from top of fixture. Use a molly style
fastener at end(s) if stud is not available.
5. Remove reflector and lamps. Position
fixture on wall level with marks made in
Step 4a. Secure to wall at each end and at
each stud.
6. Make splice in feed, reinstall reflector and
lamps.
Series 10WM Instructions - Surface Mount
98028.08/01
Finelite, Inc.
◊
30500 Whipple Road
◊
Union City, CA 94587-1530
◊
510 / 441-1100
◊
FAX: 510 / 441-1510
◊
www.finelite.com
◊
Better Lighting For A Better Workplace
Series 10 Wall Mount Installation Instructions - Surface Mount
A
A
4.5"
1.75"
2.5"
2.5"
A
1.
3.
2.
4.
6.
5.
Mark the wall at Point A.
Fixture Body
Endcap
Determine feed location
Install J-Box
Standard
4
″
x2
″
J-Box
Feed Location
Make power splice. Replace
reflector and lamps.
Screw securing fixture to wall.
Feed Hole
Remove lamps and reflector. Secure to
wall at each stud and at each fixture end.
x
x
x
fixture
stud
stud
stud
stud
stud
stud
stud
stud
fixture
Stud
= Mounting locations requiring molly style
wall fastener
= Mounting locations at studs
Secure at each stud.
Mounting Holes
= Distance between studs
x
