http://en.fineart-light.com
- 9 -
Figure 5: Lamp installation
Figure 6
2
、
Refer to figure 3, open the 1/4 turn fastener on the back of the
control panel, and draw back the lamp
holder.
3
、
Refer to figure 4, To disassembly the
lamp, loose the poles of the lamp with a
screwdriver from the socket, then pull
out two poles one by one respectively.
4
、
Refer to figure 5, To install the lamp,
Aim two poles of the lamp to the
matched socket in advance (Ensure the
direction of
lamp’s nipple toward the
socket), then push two poles into the socket synchronously.
5
、
Lift the lamp holder so that lamp is level with the center of the
reflector. Push the lamp holder straight in until it seats, make sure
the lamp passes through the reflector opening. Lastly lock the
1/4-turn fasteners.
6
、
Note: avoid any damage to lamp, during changing or installing
lamp, do not touch reflector and spare parts around.
Lamp adjustment
1
、
Switch on the fixture, and allow it to
reset. Using either a controller or the
lighting console, turn on the lamp and
project an open white beam on a flat
surface.
2
、
Using a 6-angel 3mm screwdriver to
UP-DOWN adjust the lamp until the
light spot focus in the center of light
beam vertically.
3
、
If there is big light spot, turn the top IN-OUT
adjustment screw counterclockwise until the light is evenly
distributed. If the light is brighter around the edge than it is in the
center, or if light output is low, turn the top adjustment if the light is
brighter around the edge than it is in the center, or if light output is
