Fine offset WH32M, Руководство пользователя

Страница: 8 / 24

Version 2.0 Page
8
4. After initialization, the console will instantly display indoor temperature, humidity, barometer,
moon phase, date and time. The remote search icon will turn on
：
Do not touch any buttons
until the remote sensor reports in, otherwise the remote sensor
search mode will be terminated and the search icon will turn off. When the remote sensor data
has been received, the console will automatically switch to the normal mode, and all further
settings can be performed.
3.4.4 Radio Controlled Clock (RCC)
Your console is equipped with the Radio Controlled Clock (RCC). The icon WWVB will appear
above the time to signify this.
The RCC is received by the wireless transmitter, and passed to the console. After the remote
sensor is powered up, the sensor will transmit weather data for 30 seconds, and then the sensor
will begin radio controlled clock (RCC) reception.
During the RCC time reception period (maximum 10 minutes), no weather data will be
transmitted to avoid interference.
If the signal reception is not successful (normally during the day due to solar interference), the
sensor search will be cancelled, the outdoor temperature and humidity will update as normal, and
the RCC search will automatically resume every two hours until the signal is successfully captured.
The regular RF link will resume once RCC reception routine is finished. In some locations, RCC
reception may take a couple of days to receive the signal. The temperature and humidity data will
continue to transmit during this period.
Once the radio controlled time is received, the RCC reception icon will turn on (reference
Figure 4).
3.5 Sensor Operation Verification
Verify the indoor and outdoor humidity match closely with the console and sensor array in the
same location (about 10’ apart). The sensors should be within 10% worst case (the accuracy is ±
5%). Allow about 30 minutes for both sensors to stabilize.
Verify the indoor and outdoor temperature match closely with the console and sensor array in the
same location (about 10’ apart). The sensors should be within 4°F worst case (the accuracy is ±
2°F). Allow about 30 minutes for both sensors to stabilize.
3.6 Sensor Placement
It is recommended you mount the remote sensor outside on a north facing wall, in a shaded area,