Fine Offset Electronics WH18B, Руководство по эксплуатации

Страница: 4 / 40

4
station didn
’t receive the signal in 240 minutes, the base station will start search and register
new sensor.
3. If the outdoor data lost or a battery change for the transmitter, press the reset button on the
solar power cabinet to re-send the signal and set the reregister on at display console to
register new transmitter.
4. Do not press any key before outdoor sensor data received, otherwise the outdoor sensor
learning mode will be terminated. When outdoor transmitter has been registered, the base
station will automatically switch to the normal display mode from which all further settings can
be performed by the user .
5. If there is no temperature reading in the base station, make sure the units are within range of
each other or repeat the battery installation procedure.
Note:
Commonly the radio communication between receiver and transmitter in the open field can
reach a distance of up to 330 feet providing that there are no interfering obstacles such as
buildings, trees, vehicles, high voltage lines, etc.
Radio interferences such as PC screens, radios or TV sets can, in bad cases, entirely cut off
radio communication. Please take this into consideration when choosing standing or mounting
locations.
Mounting the sensor
Important Notes :
On the edge of wind direction sensor, there are four alphabet letter of ―N‖,‖E‖,‖S‖and ―W‖
representing for the direction of North, East, South and West. Wind direction sensor has to be
adjusted so that the directions on the sensor are matching with your real location. Permanent
wind direction error will be introduced when the wind direction sensor is not positioned
correctly during installation.