Fine Offset Electronics WH18B, Руководство по эксплуатации

Страница: 3 / 40

3

High/ low alarm.

With message panel showing indication of alarms/Min/Max data, with time stamps

Light and UV index

Save the data when batteries are changed

PC software

Upload the data to internet (optional)
Set up Guide
Before placing and installing all components of the weather station at there final destination,
please set up the weather station with all parts being nearby for testing the correct function.
Setting up the base station and transmitter
1) Insert 2XAA 1,5V alkaline rechargeable batteries first into the battery compartment of the
remote sensor and immediately afterwards 3XAA 1,5V alkaline batteries in the base
station, observing the correct polarity. When battery is first inserted, the red LED light on
the remote sensor will be light up for 3-4 seconds. (If no LED light up or is lighted
permanently, make sure the battery is inserted the correct way or a proper reset is
happened)
2) When the base station is powered up, the LCD display activates for 3 seconds and after
the
―Beep‖, it begins measuring indoor temperature, humidity and air pressure. The unit
then enter the RF(Radio Frequency) state, where it receives data from the remote sensor.
RF (Radio Frequency) Receiving Mode
1. After power-on, the weather station enters RF receiving state for 180s
2. Base station receive the temperature, humidity, wind speed and rain data each 48s, receive
illuminance date each 60s. If there is no new effective signal from the sensor in constance
receiption failure in 10minutes, the outdoor temperature and humidity will
display ―----‖. If base
LED Indicator
Sensor Sockets
Battery
Compartment
Battery cover
Thermo-hygro Sensor
Setting up using batteries :