Page 3
11. Loosen the eye bolts and remove the 7” hinge bolts. Line up the
outer booms and reassemble the hinge bolt through the outer
boom yoke, the hinge casting and the spring connector. Tighten
the eye bolt until the spring is at the desired tension. Lock the
eye bolt in place with the inner whiz flange locknut.
12. Bolt on the boom extensions using the 3/8” x 1-3/4” bolts and
hex lock nuts.
Loosen nut on eye bolt
13. Hook an end of each boom chain on an “S” hook attached to the top bar tube.
14. Slip a slide clamp onto each outer boom. Place the other end of the boom chain between the ears of the slide clamp and secure with a 3/8” x 1”
flange screw. Level the outer booms by moving the slide clamps in or out as needed. Tighten the bolts in the slide clamps to hold the clamps in
place.
Slide in or out to level
15. Starting with the center section, attach the appropriate hose assemblies onto each of the three boom sections. Center the center hose assembly
on the boom, working outward to the ends of the booms. the center section has five nozzles with a cross nozzle assembly to connect your feeder
hose to. The end nozzle harness assemblies have a tee nozzle assembly to connect your feeder hose to and should be approx. 20” from the end
of your center nozzle harness assembly.
16. Join the designated feeder hose from the tee valve sub-assembly to each boom section and secure in place with hose clamps.
Your Sprayer is now ready to use.
