Fimap SMG120 B, Руководство по эксплуатации и обслуживанию

Страница: 22 / 40

22
WORK
10. Rotate the tap lever (7) in an anticlockwise direction, allowing the full passage of the detergent.
11. When the forward movement pedal (8) is pressed, the machine begins to move, the squeegee lowers
automatically and the suction motors will begin to work. Simultaneously, the brushes will begin to
rotate and the solenoid valve will begin to function.
During the first metres, check there is sufficient solution and that the squeegee dries perfectly, if this is not
the case use the tap lever (7). The machine will start working in good working order up to run out of
detergent solution or until the battery is discharged.
If the drive pedal is released, the flow of detergent will stop, the brush head and squeegee will lift off the
ground and the suction motors will continue to function for a period of time equal to 25”. If the drive pedal
is pressed again immediately afterwards, all parameters of the program which was in use prior to the
stoppage of the machine are reactivated.
27. BRAKING SYSTEM OIL LEVEL
If the red indicator light (1) comes on while the machine is in use, it means that the level of oil in the
machine's braking system has reached a critical stage which may impact upon its correct functioning.
Contact a specialised technician immediately.
28. CHOPPER CIRCUIT BOARD FAULT
If the red indicator light (2) comes on while the machine is in use, it means that a fault has occurred in the
machine's traction control circuit board. Stop the machine immediately and contact a specialised
technician.
29. SOLUTION TANK EMPTY
If the red indicator light (3) comes on while the machine is in use, it means that the level of solution in the
solution tank is too low for the machine to function properly. In this case, raise the squeegee unit and take
the machine to the area used for emptying the recovery tank. Then empty the recovery tank using the
special drainage hose. Refill the solution tank using the refill opening or the optional rapid refill kit.
30. BRUSH HEAD MOTOR UNDER PRESSURE
If the red indicator light (4) comes on while the machine is in use, it means that brush motor overload limit
level has been exceeded. The motor will come to a stop after a few seconds. To restart the motor, turn
the main switch key off and on again. If the engine stops again, check the reason of the overload in order
to prevent damage to the motor. Check to see if the problem persists when the pressure exerted on the
brushes is reduced. If it persists, contact a specialised technician.
8
1
2
3
4
7