Fimap SMG120 B, Руководство по эксплуатации и обслуживанию

Страница: 18 / 40

18
PREPARATION OF MACHINE
16. INCREASING THE PRESSURE ON THE BRUSH HEAD UNIT
This machine can increase the pressure on the brushes via the joystick (1) located on the instrument panel;
it has three different settings:
Step01: the weight exerted on the floor is 110 kg.
Step02: the weight exerted on the floor is 130 kg.
Step03: the weight exerted on the floor is 150 kg.
WARNING! The pressure must be chosen according to the type of floor
and the amount of dirt. Increasing the pressure results in greater wear and
tear on the brushes and higher power consumption (for further
information, read “CHOOSING AND USING THE BRUSHES”).
17. SOLUTION TANK
Remove the filler plug (1) at the back of the seat and check that the solution filter is installed properly.
Check that the drainage hose cap (2) located at the rear of the machine is properly closed.
ATTENTION: The recovery tank must be completely empty each time the
solution tank is filled.
18. FILLING THE DETERGENT SOLUTION TANK
Proceed as follows to fill the solution tank:
1.
Turn the main switch key anticlockwise to the “0” position
2. Engage the parking brake
3. Remove the filler cap (1) and check that the solution filter is fitted correctly
4. Fill it with clean water at a temperature not exceeding 50

C.
It is possible to fill the tank without having to constantly watch the water level, using the optional rapid filling
system (2); this system is fitted with a float to control overflow. The water pipe (previously modified) is
inserted into the quick release coupling; remember to unscrew the cap (1) to allow proper air venting.
ATTENTION: Always use detergents suitable for scrubbing machines (as
indicated on their label). Do not use acid or alkaline products or solvents
without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation than that
indicated on the label supplied.
ATTENTION: protective gloves should always be worn before handling
detergents or acidic or alkaline solutions, to avoid serious injury to the hands.
19. REGULATING THE DETERGENT SOLUTION
Firstly, fully open the outflow of the tap, by means of the lever (1) on the steering column. During the first
few metres, check that the amount of solution is sufficient to wet the floor, the amount of detergent can be
adjusted by means of the lever (1) (rotating it anticlockwise to increase the flow, or in the opposite direction
to reduce it). Bear in mind that the correct amount of solution always depends on the nature of the floor, the
degree of dirt and the forward speed.
1
1
2
1
1
2