PREPARING TO WORK
Before beginning to work, it is necessary to:
1. Check that the quantity of detergent solution present in the solution tank is suitable for the type of work to be carried out. If this is not the
case, fill the solution tank; see FILLING SOLUTION TANK.
2. Check that the condition of the abrasive pad is suitable for the work to be carried out; if it is worn, replace it. See FITTING THE ABRASIVE
PAD.
3. Carry out the steps necessary to secure the machine, see paragraph “MACHINE SAFETY” on page 14.
4. Remove the battery retainer (1) (
Fig.1
).
5. Insert the battery into the battery compartment at the rear of the machine, ensuring that the battery poles are facing towards the top of the
machine (
Fig.2
).
6. Press down on the battery until the retainers move into position.
STARTING WORK
1. Carry out all the checks listed in the chapter “PREPARING TO WORK” on page 17.
2. Switch the machine on, by pressing the main switch (1) located at the rear of the machine (
Fig.1
).
N.B.:
The main switch is in the working position when the LED inside it is on and the activation symbol is visible.
ATTENTION:
As soon as the machine is switched on, the motor in the brush head body will start working.
3. Pressing the detergent solution pump control button (2) (
Fig.2
) will dispense the detergent solution in front of the brush head body.
N.B.:
When the button (2) is released, the flow of detergent solution will stop.
N.B.:
During the first few metres of work, check that the quantity of solution is sufficient to wet the floor.
N.B.:
The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has finished.
BATTERY CHARGE LEVEL INDICATOR
The control display (3) (
Fig.3
) is located on the right-hand side of the machine body; this features three LEDs of different colours, each of which
is associated with a percentage of battery charge.
Battery level
LED on
>25%
Green
>15%
Yellow
≤15%
Red
N.B.:
After a few seconds of the battery charge reaching the critical 10% level, the brush head motor
will automatically switch off if active.
17
1
1
2
1
2
3
1
2
3