22
PREPARATION OF MACHINE
33.
EMPTY SOLUTION TANK DEVICE
To check the quantity of water in the solution tank there is a special level indicator tube (5) next to the driver's
seat.
34. WATER MANAGEMENT KIT (OPTIONAL)
If you want to increase the working capacity of the machine, you can replace the detergent solution choke
bushing (optional) on the solenoid valve with the more suitable one included in the water management kit. To do
this, proceed as follows:
1.
Make sure the solution tank is empty, otherwise empty it completely
2.
Check that the main switch of the machine is set to “OFF”
3.
Disconnect the battery connector cable from the machine connector
4.
Close the detergent solution tap (3)
5.
Remove the screw tie (1) that fixes the solution distribution tube to the solenoid valve
6.
Remove the solution distribution tube from the solenoid valve
7.
If present, remove the solution choke bushing (2) and replace it with the more suitable one, or insert the
more suitable choke bushing at the required working capacity (the choke bushings are included in the
water management kit)
8.
Reassemble all the elements
35.
BASE EXTRA PRESSER (VERSIONS B)
The pressure on the brushes can be increased by pressing pedal (8) located under the seat. Simply release the
pedal to return to the initial condition.
The pedal can also be locked in the maximum pressure position.
ATTENTION:
The pedal must be released before lifting the brush head.
The pressure must be chosen according to the type of floor and the amount of dirt. Increasing the pressure
results in greater wear and tear on the brushes and higher power consumption (for further information, read
“CHOOSING AND USING THE BRUSHES”)
If problems occur during work, turn the machine off, turn the key in the OFF position, engage the parking brake
by moving the lever (9) to the left to stop the machine and disconnect the battery connector located under the
operator. These commands block all moving machine parts. To resume work, once the problem has been
resolved, reconnect the connector, start the machine, turning the key in the ON position, release the parking
brake lever.
The machine will not start if the operator is not properly seated.
ATTENTION:
As soon as the extra pressure on the brush head has been
engaged, a green indicator light on the instrument panel will come on.
1
2