WORK
WARNING: The percentage of detergent in the solution varies from a minimum of 0.5 % to a maximum of 3.5 % with 7 set dosing
levels. The correct flow of detergent should depend on the nature of the floor; it must be proportional to the intensity of dirt on the
floor and the forward movement speed. In addition, remember that the time available for continuous working depends on the
quantity of water in the tank.
ATTENTION: If the detergent solution supply pump does not work (only for version with FSS) read the paragraph “
BYPASSING
THE WATER SYSTEM SUPPLY PUMP (only for version with FSS)
”
ATTENTION: In the event of water system malfunction, read the paragraph “
CLEANING THE SOLUTION TANK FILTER
”
or“
CLEANING THE WATER SYSTEM FILTER (only for MMx 50 versions)
”.
4.
"ECO MODE" DEVICE
By activating the “ECO-MODE” function using the relevant button (1) on the control panel, the energy used by the appliance is reduced, decreasing the
power of the brush motor and the vacuum motor. When the ECO-MODE program is activated, the wording "ECO" is displayed on the control display.
The cancel the ECO-MODE program, just press the button again. The ECO-MODE function can only be activated during the washing and scrubbing
phase (with brush head unit and squeegee head unit touching the floor) or during the drying phase (with brush head unit lifted and squeegee head unit
touching the floor).
ATTENTION: Should the squeegee head unit be lifted in ECO-MODE mode, the vacuum mode would revert to "STANDARD"
mode and continue to operate for a period of time, to then switch off automatically.
5.
OVERFLOW DEVICE
The appliance is equipped with a mechanical device (float) under the recovery tank cap that, when the recovery tank is full, shuts off the air to the
vacuum motor intake to protect it; the sound of the vacuum motor will then be deeper. If this is the case, proceed as follows:
1.
Lift the brush head unit by using the pedal located on the appliance's rear.
2.
Lift the squeegee body using the lever on the appliance's rear.
3.
Take the appliance to the designated waste water drainage area and empty the recovery tank (read the paragraph “
EMPTYING THE RECOVERY
TANK
” carefully first).
Page 22
