10
PREPARING THE MACHINE
Figure 7
To insert the batteries proceed as follows:
1.
Open the rear hook and pull out the battery compartment (1)
2.
The machine is supported by stand (2) that automatically lowers when the battery
compartment is removed
3.
Check that the trestle is in the right position.
Figure 8
4.
Put the batteries in place.
5.
Connect the cable terminals with the connector in position 01 (fig. 8)
6.
Connect the bridge cable terminals to position 02 (fig. 08).
7.
Insert the battery compartment in its housing and block everything in place with the
previously-actuated hook (fig. 7)
WARNING
: This procedure must be performed by qualified personnel.
Mistaken or imperfect connection of the cables on the batteries may cause
severe damage to persons or property
4. RICARICA BATTERIE
Figure 9
Perform a deep charge cycle before start using the machine.
If the batteries replacement needed be sure to install batteries suitable with battery charge (use
only 12V AGM o Gel batteries).
After having turned off the machine, remove the protection lid and plug the power supply cable to
the battery charger, then plug the power cable to the electric supply plug. To use properly the
battery charger refer to the battery charger manual.
WARNING:
The machine has an automatic system that remove the power
supply to the electric plant of the machine when the batteries are in
charging conditions.
WARNING:
To not damage permanently the batteries you have to not
discharge completely them to avoid a complete discharge. Recharge them
as soon as the low battery level signal appear.
WARNING:
Never left the battery totally discharged as well the machine
will not be used.
WARNING:
For the daily recharge of the batteries you need to follow
scrupulously the manifacturer indications. All the installation and
manintenance operations had to be performed by authorized personnel
only. Gas leakage and acid leakage hazards. Fire hazard, don’t approach
flames.
1
1
2
2
1
2
