20
WEEKLY MAINTENANCE
1. REPLACING THE REAR SQUEEGEE RUBBERS
Check the state of wear and tear of the rear squeegee rubbers
The rubbers should be considered worn when their profile is no longer linear (when cuts or wear can be seen on the
edge). In this case, replace them.
To replace it you must:
1.
Raise the rear squeegee
2.
Remove the two knobs
3.
dis-assemble the squeegee from its support
4.
remove the tube from the squeegee nozzle so that the squeegee can be removed
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.
ATTENTION: this operation must be carried out with the machine switched off and the
battery connector disconnected
5.
Unscrew the knobs on the squeegee that block the rubber-pressing blades and remove them
6.
Remove the rubber-pressing blades
7.
Turn the rubbers upside down, or replace them
8.
Reassemble everything, carrying out the above-mentioned operations in the reverse order.
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.
2. REPLACING THE FRONT SQUEEGEE RUBBERS
Check the state of wear and tear of the front squeegee rubber
The rubber should be considered worn when its profile is no longer linear (when cuts or wear can be seen on the edge).
In this case, replace it.
To replace it you must:
1.
Raise the front squeegee
2.
Remove the two springs (A) and unthread the two fixing pins (B)
3.
Dis-assemble the squeegee from the supports
4.
remove the tube from the squeegee nozzle so that the squeegee can be removed
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of
serious injury to hands.
ATTENTION: this operation must be carried out with the machine switched off and the
battery connector disconnected
