12
MACHINE PREPARATION
9. BATTERY
INDICATOR
The battery indicator is digital, with 4 fixed positions and a flashing one. The numbers that appear on the display
show the approximate charge level.
4 = maximum charge, 3 = 3/4 charge, 2 = 2/4 charge, 1 = 1/4 charge, 0 = batteries run down (flashing)
ATTENTION: A few seconds after the appearance of the flashing “0”, the brush motor
switches off automatically. With the remaining charge it is still possible, however, to
complete the drying process before recharging
10. INSTRUMENT PANEL COMPONENTS
The instrument panel components are identified as follows:
1.
Main switch (1)
2.
Suction switch (2)
3.
Solenoid valve switch (3)
4.
Digital battery level indicator (4)
11. ASSEMBLING THE BRUSHES
The brushes are supplied loose in order to prevent the bristles from being crushed inside the packaging. To
assemble them, proceed as follows:
1.
loosen the three wing nuts fixing the side cover of the tunnel
2.
remove the side cover
3.
insert the light blue brush at the rear, with the five grooves facing inwards
4.
insert the white brush at the front, with the five grooves facing inwards
5.
re-assemble the side cover, being sure to insert the hub pins correctly in the brush grooves. If this proves
difficult, rotate the brush manually until the pins are in line with the grooves
6.
fasten the cover by tightening the three wing nuts
ATTENTION: users are advised to always wear protective gloves, to avoid the risk of serious
injury to hands.
Take care not to mix up the brushes, the blue brush should always be placed in the rear idle hub.
Take care how the brushes are mounted, the assembly is correct if the direction of the bristles form an X looking from
above.
4
2
3
1
