18
6 STARTING
Warning! If the appliance has been laid down or turned upside
down, you should wait at least 8 hours before starting it.
5.4 ELECTRICITY
CONNECTION
Connection to the mains electricity supply is carried out by connecting the
SOXJWRDPDLQVVRFNHW7KHVXSSO\VRFNHWPXVWEHHTXLSSHGZLWKDQHI¿
-
cient earth plate and it must be sized for the load of the appliance (see tech-
nical characteristics). Make sure that the mains voltage corresponds with
ZKDWLVVSHFL¿HGRQWKHGDWDSODWH0DNHVXUHWKDWWKHUHLVDQRPQLSRODU
switch above the socket with a minimum contact break of 3 mm protected
by fuses of suitable amperage for the absorption of the appliance itself (see
technical characteristics and data plate).
Turn on the water tap and make sure there are no leaks.
Turn on the main ON/OFF switch
4
.
Turn the tap to the position marked
to eliminate all remaining air in
the soda water circuit (WG models).
Turn the tap to the position marked
to eliminate all remaining air in
GB
the cold water circuit.
Adjust cold water thermostat
8
depending on use and season (positions
recommended from 4 to 7).
6.2 CO
2
GAS CYLINDER CONNECTION (CARBON DIOXIDE)
In this water cooler model, the CO
2
can be connected only outside the ma-
FKLQH¿JDOORZLQJWKHXVHRIUHFKDUJHDEOHF\OLQGHUVDVZHOO
&$87,21GRQRWSDVVWKHF\OLQGHU¶VFRQQHFWLQJSLSHLQIURQWRIWKH
KHDWRXWOHWYHQW¿J
Take the ø6 mm pipe out of the installation kit and connect it to the R
SUHVVXUHUHGXFHURQWKHF\OLQGHU¿J
Insert the other end of the pipe on the IN CO
2
connector at the top of the
device; make sure you insert it correctly.
The cylinder is provided with a sealing valve which will open during reducer
assembly and will close automatically during disconnection. The reducer
regulation screw R is already calibrated in the optimal pressure setting (ap-
proximately 3.5 bar). In any case, the quantity of gas supplied can be in-
creased by turning the screw in the clockwise direction, and vice versa. 600
g. rechargeable CO
2
cylinders can charge approximately 120 liters of water.
6 START
Advarsel! Hvis apparatet var lagt ned, eller hvis det var vendt,
bør man mindst vente 8 timer før starten.
5.4 ELEKTRISK
FORBINDELSE
Forbindelsen til det elektriske net sker ved at forbinde stikket til lysnettets stik-
kontakt. Stikkontakten til forsyningen bør være udstyret med en effektiv jordfor-
DK
bindelse, og den bør svare til apparatets last (der henvises til afsnittet ”Tekni-
VNH.DUDNWHULVWLNNHU´.RQWUROOHUDWQHWVS QGLQJHQVYDUHUWLOVSHFL¿NDWLRQHUQH
som er angivet på dataskiltet. Kontroller at der er oven på stikket er en afbryder
kompatibel med alle poler, og med en afstand på mindst 3 mm mellem kon-
takterne, og beskyttet med sikringer. der har en strømstyrke, som egner sig til
apparatets absorption ( se de tekniske karakteristikker og dataene på skiltene).
13
14
IN CO
2
16
15
R
5
4
