Filtec FT-70c, Сервисное и техническое руководство

Страница: 94 / 243

Chapter 4: Configuring the FT-70 for Operation
4-25
Configure the Down Can Function
1. If your FT-70 is not in the Calibrate Mode, Press Key 5 until you
reach SYSTEM DISPLAY and then press the Arrow Key to
enter the Calibrate Mode.
2. Open dip switch S1-5.
3. Press Key 5 until DOWN CAN appears and use the Arrow Key
to select PRESENT.
4. Close dip switch S1-5.
5. Press Key 2 until DOWN CAN STATUS appears and then press
the Arrow Key to activate the function.
6. Measure the width of the can in millimeters at the point where
the can (in the upright position) intersects the down can sensor
beam. This is the Width at Down Can.
7. Press Key 2 until WIDTH AT DOWN CAN appears and then
press the Arrow Key to enter the measurement value.
8. Measure the height of the can in millimeters. Be sure to
measure from the bottom to the top of the lid (highest part).
9. Press Key 2 until HEIGHT OF CAN appears and then press the
Arrow Key to enter the measurement value.
10. If you are finished configuring the FT-70, press Key 5 until you
reach SYSTEM DISPLAY and then press the Arrow Key to
return to the Operate Mode.
11. Calibrate the Bulged End Sensor according to the instructions
in
Chapter 6, Calibrating the Down Can Sensor .
Industrial Dynamics Company, Ltd. © Form
40256-0600