12
FIK-5496 Manual —
P/N LS10253-001FK-E:A 03/02/2021
Hardware Installation
Connecting the FIK-5496 to the FACP
3.3 Connecting the FIK-5496 to the FACP
1.
Connect the FIK-5496 to the appropriate SBUS. The FIK-5496 is connected directly to a Fike addressable FACP.
2.
Use the onboard dipswitch to assign an ID number to the FIK-5496. (See Section Figure 3.4 on page 12).
Figure 2.1 on page 7 shows the location of the Dip Switches on the FIK-5496 board.
3.
To configure the FIK-5496 module and add it to the System, use either the JumpStart program or manually add it to the System. You
can also assign a name to the module. These procedures are described in the following Fike addressable FACP Installation Manuals that
are located on the on Fike’s website at www.fike.com..
Figure 3.3 Class B FIK-5496 Connection to FACP
3.4 Setting the Device ID
All SBUS modules in the System must have a unique number (1-31) to identify them to the FACP. Use the DIP switch on the FIK-5496
board to set the module ID number. Figure 2-1 on page 2 shows the location of the dipswitch on the board. Figure 3.4 on page 12 shows dip-
switch setting and the corresponding module ID numbers.
Figure 3.4 Possible Module Addresses
Document
Document Part Number
Document
Document Part Number
FCP-2100/ECS Manual
LS10143-002FK-E
FIK-5496 Manual
LS10253-001FK-E
FCP-300/ECS Manual
LS10145-001FK-E
FIK-RPS1000 Manual
LS10259-001FK-E
FCP-75 Manual
LS10147-002FK-E
FIK/ECS Manual
LS10262-001FK-E
FIK-5496
Board
Supervised
Power-Limited
(MAIN SBUS)
