ECS Series Manual —
P/N LS10262-001FK-E:A 3/3/2021
63
Addressing SBUS Devices
Device Installation
4.
Push the strain into the hole in the dead front panel.
4.10.4 To Remove the FIK-RVM
To remove the FIK-RVM follow these steps:
1.
Remove AC power and disconnect batteries from the main control panel.
2.
Disconnect the SBUS connections from the SBUS terminals on the FIK-RVM. See Figure 4.60.
3.
Disconnect any devices connected to the VBUS. See Figure 4.59.
4.
Unplug the microphone from the microphone connector. See Figure 4.66.
Figure 4.66 Back View of FCP-300ECS or FCP-2100ECS Dead Front Panel
5.
Remove the six ¼” hex nuts that hold the FIK-RVM in place.
6.
Lift the FIK-RVM off of the dead front panel.
4.11 Addressing SBUS Devices
When installing a hardware module (such as FIK-6815, FIK-5824, FIK-RA1000, FIK-RA100, FIK-RA2000, FIK-5496, FIK-RPS-1000,
FIK-5865-3 or FIK-5865-4, FIK-50W, FIK-125W, FIK-DUAL50W, FIK-NVCM and FIK-RVM), you must use the DIP switches on the
module to assign an ID# to the module.
