2
2-11
Network Setup options
3.
To use Ethernet, choose Ethernet Setup, choose the protocol, and enter the appropriate
settings.
4.
When you have finished entering settings for one protocol, either select Ethernet
Setup again and select another protocol that you use, or choose Exit Network Setup.
5.
To use token ring, choose Token Ring Setup, and then choose the appropriate token
ring and IPX settings.
6.
To use the parallel port, choose Parallel Port Setup and enter the appropriate settings.
7.
When you have finished entering network settings, choose Exit Network Setup.
8.
Choose Yes when prompted to save changes.
9.
From the main setup menu, choose another setup or choose Exit Setup.
For first time setup, or if you have configured a new connection, choose Printer Setup
after you finish Network Setup.
Ethernet Setup options
AppleTalk Zone
list of zones
The Fiery SI searches the network for AppleTalk zones. Scroll through the list to select
the AppleTalk zone in which you want the Fiery SI to appear. If you do not enter a
zone, the Fiery SI is assigned to the default AppleTalk zone.
The alert “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see page 4-3). Choose OK.
You can enable AppleTalk, TCP/IP, and IPX (Novell) communication simultaneously
on Ethernet cabling. To configure the Fiery SI, choose each protocol and enter the
settings for that protocol. Since network setups are nested, the names of higher-level
menus are shown in this chapter to the left of each menu heading.
Network Setup
Ethernet Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery SI. This setting
enables the Fiery SI to communicate over AppleTalk networks.
Exit Ethernet Setup
AppleTalk Setup
TCP/IP Setup
IPX (Novell) Setup
Ethernet Setup