Fieldmann FZP 6005-E, Руководство по эксплуатации

Страница: 27 / 110

27
OPERATING INSTRUCTIONS POLE-MOUNTED PRUNER
EN Sawchain replacement
14. SAWCHAIN REPLACEMENT
ATTENTION!
When replacing the saw chain, do not fix the chainsaw or the guide bar into
the chops.
Always replace the chain if the teeth are excessively worn out or cannot be sharpened or if the
chain breaks. Use only original replacement chain according to specification in this instruction
manual. When replacing a chain, always replace the sprocket wheel too. This way you ensure the
correct position of the chain during movement. (Note: The specification of the correct chain and
sprocket type is available in the List of Parts.)
When performing the following steps, make use of the drawing in Fig. No. 1.
Loosen and remove the guide bar bolt.
Remove the sprocket cover.
Remove the saw chain.
Place the new chain around the sprocket wheel, along the top groove of the guide bar and
around the guide bar nose.
Note:
Make sure the cutting edges of the chain are facing in the correct direction. Position
the chain so the cutting edges on top of the guide bar face to the guide bar nose (40) (see
Fig. 17 and arrow on the saw side cover).
Before placing the sprocket cover into position, check whether the adjusting tip is inserted into
the adjusting hole of the guide bar.
Reinstall the sprocket cover back to the saw body.
Attach the sprocket cover using the guide bar bolt.
ATTENTION!
Use only your hand while tightening the bolt.
Adjust the tension of the saw chain.
Tighten the guide bar bolt using a hexagonal wrench.
ATTENTION!
Make sure you did not place the saw chain onto the guide bar in the opposite
direction. Otherwise, the saw will produce excessive vibrations and will not cut.