Fieldmann FZP 6005-E, Руководство по эксплуатации

Страница: 23 / 110

23
OPERATING INSTRUCTIONS POLE-MOUNTED PRUNER
EN Adjusting chainsaw head angle | Adjusting telescopic pole length
Operating the pole-mounted pruner
9. ADJUSTING CHAINSAW HEAD
ANGLE
(Fig. 9)
The chainsaw head can be adjusted up to 3 different working angles. 0 degrees, 15 degrees
and 30 degrees.
With one hand press the adjusting button PUSH and turn the trimmer head into the desired
position. After releasing the button, the trimmer head is automatically locked in the set
position.
10. ADJUSTING TELESCOPIC POLE
LENGTH
The chainsaw is equipped with a telescopic pole the length of which ranges from 2.0 m (fully
retracted) up to 2.6 m (fully extracted). The locking bush with arresting element will ensure
sufficient strength of the pole in any length.
To extend the pole, loosen the arresting element (9) in the direction (A) (see Fig. 10). The pole
can be easily extracted.
Pull the front part of the pole and extract it up to the desired length. Note: Always extend the
pole only up to the minimum length required for cutting the particular shrubbery.
To lock the pole in the position, tighten the arresting element (9) in the direction (B)
(see Fig. 10).
11. OPERATING THE POLE-MOUNTED
PRUNER
Fill up the oil container.
Plug the power cord to the outlet.
Grasp the chainsaw pole with your both hands. Hold the pole at prescribed grip positions
(A) and use the supporting strap. (see Fig. 11) Hold the pole firmly. The thumbs and fingers
must firmly wrap both the pole and the handle of the tool.
Stand so that you are stable and balanced. Stand with your legs apart. Distribute your weight
evenly on both feet.
As soon as you are ready to trim, press the trigger lock (28) and subsequently the actual tool
switch (17) (see Fig. 12). This will start the chainsaw. Once the switch is released, the
chainsaw stops. Before cutting, the chainsaw must always be running.
When cutting, place the moving saw chain near the branch. Hold the chainsaw telescopic
pole firmly to avoid undesired bouncing or side sliding of the saw.