Fieldmann FZP 6005-E, Руководство по эксплуатации

Страница: 26 / 110

FZP 6005-E
26 EN Sawchain sharpening
Note:
The figure shows the position of the guide rail of the file and the teeth filing direction
on the left side of the chain.
Place the file guide rail to the desired angle (mark A, Fig. 14). Check whether the mark 30° on
the file guide rail is aligned with the centre of the guide bar. This way you make sure you are
filing under the angle of 30°.
1
2
3
4
5
6
7
1 -
2 -
3 -
4 -
5 -
6 -
7 - Right-hand side of the chain
Upper plate, right-hand side of the chain
Raker, right-hand side of the chain
Groove
Raker, left-hand side of the chain
Groove
Upper plate, left-hand side of the chain
File the tooth from inside out (in the direction B, Fig. 14) until it is sharp. File only in this
direction.
Note:
Two or three file strokes should suffice to make the tooth sharp.
Raker filing
Sharpening of the chain teeth will result in reduced tolerance of the raker. After each second or
third sharpening, it is necessary to adjust the raker.
Place the tool for raker modification (.025“) (35) firmly onto the top edge of two teeth. Make
sure the groove of the tool snapped into the groove of the raker (36) (see Fig. 15).
Use middle-sized flat file (32) (see Fig. 15). File the raker (37) down to the level of the tool for
raker modification.
Remove the tool for raker modification. Using a flat file (32) round off the front side (38) of the
raker (see Fig. 16).
Note:
After a few manual sharpening hand the saw chain for sharpening to an authorised
service centre or sharpen it using a special sharpening machine. This way you will restore
even sharpening of all teeth.