Fieldmann FDB 202201-E, Инструкция по эксплуатации

Страница: 14 / 131

Additional safety instructions for cutting
Additional safety warnings specific for abrasive cutting:
Additional safety instructions for surfacing
Safety warnings specific for surfacing:
Additional safety instructions for polishing
Safety warnings specific for polishing:
-Cutting disk may not strike material or exert excessive pressure. Do net attempt to
achieve excessive depth of cut. Overloading of the disk increases the risk of distortion
or seizing of the disk and kick-back or breaking of the disk.
Do not stand in line with the rotating disk or behind it. In the moment when a disk is
moving in the point of contact away from the operator's body, kick-back may throw the
spinning disk and electromechanical tool directly on the operator.
If the disk seizes or cutting is interrupted for any reason, electromechanical tool has to be
switched off and held motionless, until the disk stops completely. The operator may not
attempt to remove the cutting disk from a cut while the disk is moving, because it may
cause a kick-back. Check the situation and take steps to prevent seizure of the disk.
Do not start the cutting in the work piece again. Let the disk to reach full speed and insert it
carefully into the cut. It the tool is restarted with the disk inserted in the cut, it may lead to
its seizure, pushing up or a kick-back.
Panels and other large work pieces have to be supported to reduce the risk of seizure and
kick-back. Large pieces of work have a tendency to bend under its own weight. The supports
have to be placed beneath the work piece close to the line of cutting and close to the edges
of the work piece on both sides of the disk.
Pay special attention while "cutting into a cavity" into current walls of other blind spaces.
The penetrating disk may cut through a gas or water line, electric cables or objects, which
may cause a kick-back.
Do not use sand paper of excessive size for the grinding disk. Follow the manufacturer's
instructions while selecting the sand paper. Large sand paper, which extends over the
grinding disk, represents a risk of tearing and may cause seizure, tearing of the disk or a
kick-back.
Do not let any loose parts of the polishing sleeve or its attachment strings rotate freely.
All lose attachment strings have to be slipped beneath or cut away. Loose and rotating
attachment strings may get caught in the operator's fingers or in the work piece.
1 4
FDB 202201-E
ELECTRICAL ANGLE GRINDER
EN Specific safety instructions | Use and operation