INSTALLER SECTION
This manual is separated into two different sections: one for the Homeowner and one for the System Installer.
The Installer section contains setup and installation information of the remote control with optional user
settings available for the homeowner.
CAUTIONS
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
!
INSTALLATION
Read and follow all instructions carefully.
i
ATTENTION INSTALLER
Install and wire components to the wiring hub. (See
H32 Wiring Hub manual for wiring detail)
Read entire manual before installing EvenAir products.
After testing wiring hub and components installation,
place the remote control on the subbase or attach table
top adapter.
1)
3)
Install the ER1 electronic receiver module in the wiring
hub. The remote control is factory set to sensor #2.
Set the home number as necessary.
(see H32 Wiring Hub manual).
2)
i
Homes with plaster walls with steel lathe may
experience wireless communication interference
when using wireless remote controls.
Install batteries in remote control and set time (see
Installing Batteries and Set Time section).
4)
Linked should be displayed. Verify the wireless
communication by observing that the outdoor
temperature is displayed correctly.
5)
INSTALL TSRC REMOTE CONTROL
The TSRC can be installed on an interior wall using the subbase
provided or can be set on a table top using the table top
adapter provided.
WALL MOUNTING
Attach the subbase to a wall
using the screws and anchors
provided. The TSRC snaps onto
the subbase. No wiring is
required.
TABLE TOP USE
Snap the tabletop adapter onto
the TSRC and place on table top.
INSTALL BATTERIES
Install 2 AA batteries.
P/N 780101745 3/18 Rev A
page 6 of 8
