QUICK START GUIDE
Fidelis Network® Collector SA
www.fidelissecurity.com
©Fidelis Cybersecurity
6
3. If you see the screen above, perform the following steps to apply the software. Otherwise
skip to step 4.
a. With
Perform Initial Install or Factory Reset
selected, press Enter.
b. Use the Up and Down arrow keys to select
the system type
Collector SA
, and press
Enter.
If you need help determining the system type,
see
The system displays a screen with the
message “Congratulations, your CentOS
installation is complete.”
c. Click
Reboot
.
4. Login to the appliance using console or SSH.
Via SSH:
Directly attach an Ethernet cable from a client system such as a laptop to the
Admin/eth0 port on the appliance. The default IP address is 192.168.42.11/24. Assign a
static IP from the same subnet to the network interface on the client system and connect to
the appliance using SSH.
5. Use these credentials at the login prompt:
−
user:
fidelis
−
default password:
fidelispass
6. From the command line, run:
sudo /FSS/bin/setup
You will be prompted for the SU (fidelis) password.
7. Within Setup, select
Network Settings
.
8. Configure the network parameters for the system and each active network interface.
−
Use the Network Configuration table you prepared earlier.
−
When complete, return to the top menu.
9. When complete, select
OK
to leave Setup.
10. From command line, reboot the system:
sudo /fss/bin/shutdown.pl --user admin --reboot
