FiberLamp FL210, Руководство по эксплуатации

Страница: 11 / 22

FiberLamp DMX Operation Page 10 of 214
Copyright 2013

5870004A3
8. When the “Save Current Scene” pop-up window appears, create a name for the Profile being
saved, type it in the designated box, and click “OK”. The Profile name will then appear in the
“Saved Profile” section with the extension .fsc.
9. Repeat 1-8 above until all of the desired Profiles are created, saved and can be found as a
.fsc file in the in the “Saved Profile” section.
10. In the order in which the Playlist will play the selected Profiles, click and drag Profiles from
the “Saved Profiles” section to the “Selected Profiles” section. The Profile names will appear
in the “Selected Profiles” in the order in which they were dragged over. If any Profiles were
dragged over to the “Selected Profiles” section out of order, select the Profile and click the
“Remove” button, then proceed with dragging Profiles to the “Selected Profiles” section in the
correct order.
11. If the Profile sequence is correct, it can be saved as a Playlist to any location on the PC by
clicking the “Save” button on the right-hand side of the “Selected Profiles” section.
12. Select the appropriate location on the PC to save the Playlist, name it and save. The Playlist
will be saved with the extension .fpl, can be loaded to the “Selected Profiles” section anytime
in the future by clicking the “Load” button.
Writing a Playlist to the FiberLamp
1. Fill the “Selected Profiles” section with the desired sequence of Profiles by dragging Profiles
in order from the “Saved Profiles” section, or load an existing Playlist by clicking the “Load”
button and selecting the desired Playlist. To preview the Playlist before it is written to the
FiberLamp, click the “Preview” button.
2. With the correct Playlist loaded to the “Selected Profiles” section, in the “Write Selected
Profile to FiberLamp” section, select the Playlist Number to which the Playlist will be written.
(Note: Playlist Numbers 1-4 correspond to pushbutton modes 8-11, respectively)
3. Click the “Write” button on the right-hand side of the “Write Selected Profile to FiberLamp”
section.
4. When the “Write to FiberLamp” pop-up window appears, click “Yes”.
5. Use the pushbutton to verify that the Playlist has been saved in the correct mode position.
Setting the DMX Address
1. In the “DMX Address” tab, select the Base Address number that corresponds to the first of
the reserved DMX addresses for the FiberLamp in a DMX512 network. (See section 6 for
FiberLamp DMX address control features)
2. Click the “Set” button.
3. When the “Set DMX Address” pop-up window appears, click “Yes”.
Setting the DMX Mode
1. In the “DMX Mode” tab, select Master if the FiberLamp is to act as a DMX Master, or Slave if
the FiberLamp is to act as a DMX Slave. (See section 6 for DMX Master/Slave definitions)
2. Click the “Set” button.
3. Click “OK” when the pop-up appears.