Fiat 500X 2021, Руководство пользователя

Страница: 195 / 336

SAFETY 193
Traction Control System (TCS)
The TCS monitors the amount of wheel spin of
each of the driven wheels. If wheel spin is
detected, the TCS may apply brake pressure to
the spinning wheel(s) and/or reduce vehicle
power to provide enhanced acceleration and
stability. A feature of the TCS, Brake Limited
Differential (BLD), functions similarly to a
limited slip differential and controls the wheel
spin across a driven axle. If one wheel on a
driven axle is spinning faster than the other, the
system will apply the brake of the spinning
wheel. This will allow more vehicle torque to be
applied to the wheel that is not spinning. BLD
may remain enabled even if TCS and ESC are in
reduced modes.
AUXILIARY DRIVING SYSTEMS
B
LIND
S
POT
M
ONITORING
(BSM) — I
F
E
QUIPPED
BSM uses two radar sensors, located inside the
rear fascia/bumper, to detect highway
licensable vehicles (automobiles, trucks,
motorcycles, etc.) that enter the blind spot
zones from the rear/front/side of the vehicle.
Rear Detection Zones
When the vehicle is started, the BSM Warning
Light will momentarily illuminate in both outside
rearview mirrors to let the driver know that the
system is operational. The BSM system sensors
operate when the vehicle is in any forward gear
or REVERSE and enters standby mode when the
vehicle is in PARK.
The BSM detection zone covers approximately
one lane width on both sides of the vehicle,
10 ft (3 m). The zone length starts at the
outside mirror and extends approximately 20 ft
(6 m) beyond the rear fascia/bumper of the
vehicle. The BSM system monitors the
detection zones on both sides of the vehicle
when the vehicle speed reaches approximately
6 mph (10 km/h) or higher and will alert the
driver of vehicles in these areas.
NOTE:

The BSM system DOES NOT alert the driver
about rapidly approaching vehicles that are
outside the detection zones.

If a trailer is connected to the vehicle, it is
necessary to deactivate BSM system manu -
ally by settings menu to avoid a misdetection
Ú
page 134.
The area on the rear fascia/bumper where the
radar sensors are located must remain free of
snow, ice, and dirt/road contamination so that
the BSM system can function properly. Do not
block the radar sensors located on the rear
fascia/bumper with foreign objects (bumper
stickers, bicycle racks, etc.).
Rear Sensor Locations
6
21_FD_OM_EN_USC_t.book Page 193