Back Panel
：
1) DC12V: DC12V /2A power input interface;
(2) PWR: power indicator light, which means the power supply of the equipment is normal; otherwise, the power
supply is abnormal;
(3) SYS: Status indicator light. The flashing light indicates normal operation of the device; otherwise, the device fails;
(4) ETHERNET: 10M/100M ETHERNET interface;
(5) RESET: RESET to factory setting, long press for 5 seconds.
(6) RS232: Support central control command and camera tracking,RX: receive data,TX: send data,G: ground wire;
(7) RS485: Supporting camera tracking;
(8) GPIO: GPIO control;
(8) OUTPUT: Analog Output;
(9) INPUT: Analog Input
Use and operation steps
1 Web control and software download
The factory default IP address of the device is: 192.168.1.200 Subnet mask: 255.255.255.0. Please add the address
of the network segment to the PC first, so that the device can connect normally.
After the device is started, use a web browser to access the address "http://192.168.1.200/", as shown in the figure
below:
