Festool T18+3, Оригинальное руководство пользователя

Страница: 16 / 78

< 15%
*
*
Recommendation: Charge the battery pack
before any further use.
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
8 Settings
CAUTION
Risk of injury
► Only adjust the settings when the power
tool is switched off.
8.1 Changing direction of rotation [1-6]
– Switch to the left = clockwise rotation
– Switch to the right = counterclockwise rota­
tion
8.2 Changing gear [1-8]
Only actuate the gear switch with the tool
switched off. Otherwise there is a risk of
damaging the gear unit.
• Gear switch forwards (digit 1 visible) =
1st gear
• Gear switch to rear (digit 2 visible) =
2nd gear
8.3 Fastening
Adjust the switch so that its marking [1-11]
faces the screw symbol [1-10].
Adjust the torque accordingly at the torque
wheel [1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset tor­
que is reached and the machine then switches
off. You must release and press the ON/OFF
switch [1-5] again to start the machine.
8.4
Drilling
Adjust the switch [1-11] so that its marking
faces the drilling symbol [1-9]. Maximum tor­
que is set in this position.
9 Tool holder, attachments
WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
9.1 CENTROTEC tool chuck [3]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CEN­
TROTEC tool chucks.
9.2 Chuck [4]
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
WARNING! Clamp the tool centrally in the
chuck.
9.3
Angle attachment [5]
Drilling and screwdriving at right angles to the
power tool (available as an accessory depend­
ing on the model).
9.4
Eccentric adapter [6]
Screwdriving close to edges with bits according
to ISO 1173 (available as an accessory depend­
ing on the model).
9.5
Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
10 Working with the machine
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
10.1 Bit depot [1-4]
Magnetic, for storing bits and bit holders.
10.2 Acoustic warning signals
Acoustic warning signals sound and the ma­
chine switches off in the following operating
states:
English
16