Festool SHINEX RAP 150 FE, Оригинальное руководство по эксплуатации/список запасных частей

Страница: 14 / 86

14
SHINEX
GB
erator can control torque reactions or kick-
back forces, if proper precautions are taken.
– Never place your hand near the rotating
accessory.
Accessory may kickback over
your hand.
– Do not position your body in the area
where power tool will move if kickback
occurs.
Kickback will propel the tool in di-
rection opposite to the wheel’s movement at
the point of snagging.
– Use special care when working corners,
sharp edges etc. Avoid bouncing and
snagging the accessory.
Corners, sharp
edges or bouncing have a tendency to snag
the rotating accessory and cause loss of
control or kickback.
– Do not attach a saw chain woodcarving
blade or toothed saw blade.
Such blades
create frequent kickback and loss of control.
Safety Warnings Specific for Polishing
Operations
– Do not allow any loose portion of the
polishing bonnet or its attachment
strings to spin freely. Tuck away or trim
any loose attachment strings.
Loose and
spinning attachment strings can entangle
your fingers or snag on the workpiece.
– Prevent liquid polish from entering the
machine.
The penetration of liquid polish
into the electric power tool increases the risk
of an electric shock.
5.3 Emission levels
Levels determined in accordance with EN
60745 are typically:
Vibration emission value a
h
(vector sum for
three directions) and uncertainty K measured
in accordance with EN 60745:
The emission values specified (vibration,
noise) were measured in accordance with the
test conditions stipulated in EN 60745 and are
intended for machine comparisons. They are
also used for making preliminary estimates re-
garding vibration and noise loads during oper-
ation.
The emission values specified refer to the
main applications for which the power tool is
used. If the electric power tool is used for oth-
er applications, with other tools or is not main-
tained sufficiently prior to operation, however,
the vibration and noise load may be higher
when the tool is used. Take into account any
machine idling times and downtimes to esti-
mate these values more accurately for a spec-
ified time period. This may significantly reduce
the load during the machine operating period.
6 Operation
The switch [1-4] is an on/off switch (press =
ON, release = OFF).
The locking button
[1-3] can be engaged to
operate in continuous mode. Press the switch
again to release the knob.
7 Settings
Sound pressure level L
PA
= 81 dB(A)
Noise level L
WA
= 92 dB(A)
Uncertainty K = 3 dB
CAUTION
Operating noise
Damage to hearing
X
Use ear protection!
Machine housing a
h
< 2,5 m/s
2
K = 1,5 m/s
2
Additional handle a
h
< 2,5 m/s
2
K = 1,5 m/s
2
WARNING
Unauthorised voltage or frequency!
Risk of accident
X
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
WARNING
Risk of injury, electric shock
X Always pull the plug out of the socket be-
fore performing any type of work on the
machine!