Festool LHS-E 225 EQ, Оригинальное руководство по эксплуатации

Страница: 21 / 24

21
LHS 225-E
Problem Possible causes Remedy
Sanding marks on the
surface Sanding pad is placed down
on the surface at an angle Place the sanding pad down so that it is
level.
The abrasive grit is too
coarse for very soft
spackling paste Choose a finer abrasive grit (abrasive
Brilliant 2 available up to grit P 320).
LHS 225-E switches
off while working and
after three beeps Cool air filter on the
LHS 225-E is blocked Clean the cool air filter on the LHS 225-E,
see Section 9.1.
Excessive pressure –> power
tool activates overheating
protection Let the power tool cool down for approx.
15 minutes and then apply less pressure.
LHS 225-E not working Plug it is not connected
correctly
Check that the plug it is securely
connected.
Interruption to power supply Switch the power tool off and on again.
LHS 225-E not working
and beeps three times
when an attempt is
made to switch it on Overheating protection active Let the power tool cool down for approx.
15 minutes before switching it bak on
again.
Information on data protection
The power tool contains a chip which automatically
stores machine and operating data (RFID). This
data saved cannot be traced back directly to an
individual. The data can be read using special
(contactless) devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or
enhancement of the power tool. The data shall
not be used in any other way without the express
consent of the customer.