Festool LHS-E 225 EQ, Оригинальное руководство по эксплуатации

Страница: 18 / 24

18
LHS 225-E
7.2 Replacing the sanding pad [3]
Observe the following instructions:
– An optimal work result can only be achieved using
original accessories and consumables. The use
of non-original accessories or consumables
invalidates the right to claim under warranty.
– Only fit and remove the sanding pads using the
tool supplied.
– Make sure that both flat edges engage in the
opening on the sanding pad.
7.3 Changing the sanding discs [6]
Compatible StickFix sanding discs are quick and
easy to attach to the StickFix sanding pad.
CAUTION! The holes in the sanding disc
must be aligned with the holes in the
sanding pad.
Otherwise, the suction
power is impaired and there is more ex-
posure to dust.
Do not use interface pads.
7.4 Sanding close to edges [7]
The removable brush segment means that the
distance at the side between the wall/ceiling and
the sanding pad is reduced.
CAUTION! Without a brush segment,
there is more exposure to dust:
Only re-
move it for specific applications.
The brush segment is fitted in reverse order to
the process for removing it.
7.5 Dust extraction
WARNING
Health hazard posed by dust
X
Always work with an extractor.
X
Comply with national regulations.
X
Wear a dust mask.
A Festool mobile dust extractor with an extractor
hose diameter of 27 mm or 36 mm (36 mm
recommended due to the reduced risk of clogging)
can be connected to the extractor connector
[1-4] .
Festool CTL/M 36 E AC PLANEX mobile
dust extractors are adapted to the quantity
of dust generated and permanently ensure
the necessary suction power.
Recommendation : Use an antistatic suction hose.
This helps reduce the electric charge.
8 Working with the power tool
WARNING
Risk of injury
X
Do not hold the power tool by the sanding
head.
X
Hold the power tool with both hands using
thegripping surfaces
[1-10].
X
To switch on the power tool, see Section 6.
X
Carefully place the sanding head onto the
sanding surface.
X
Perform the sanding work.
Do not apply too much pressure on the
power tool as this will cause over loading.
The best sanding results are achieved
with moderate application pressure. The
sanding performance and quality depend
mainly on selecting the correct abrasive.
After finishing work
X
Once you have finished the sanding work, set
the power tool down.
CAUTION! Do not set the power tool down
with the sanding head facing downwards
– always lay it on the floor so that it is
on its side with the brush ring facing
down.
Otherwise the sanding pad could
be deformed.
To protect the sanding pad and the
sanding head, always transport and store
the power tool in the accompanying carry
bag without the sanding discs.
9 Service and maintenance
WARNING
Risk of injury, electric shock
X
Always disconnect the mains plug from the
socket before performing maintenance work
on the machine!
X
All maintenance and repair work which re-
quires the motor housing to be opened must
only be carried out by an authorised service
workshop.