Festool HK 55 EQ, Оригинальное руководство пользователя

Страница: 15 / 48

6 1
2
6-1
6-2
6-3
9 Working with the electric
power tool
Please observe all mentioned safety in­
formations and the following rules when
working:
– Only guide the machine against the work­
piece when it is switched on.
– Check the function of the pendulum guard
prior to use and do not use the electric
power tool if it does not slide in and out
easily.
– Always secure the workpiece in such a
manner that it cannot move while being
processed.
– Always hold the machine with two hands at
the handles [1-1] when performing work.
This reduces the risk of injury and is a pre­
requisite for precise work.
– Always push the saw forwards [8-9] , and
never towards yourself.
– Adapt the infeed speed to prevent the cut­
ters on the saw blade from overheating and
prevent plastic materials from melting dur­
ing cutting.
– Make sure that the knob [1-12] is tightened
before starting work.
– Do not use the machine when the electron­
ics are faulty because the machine may op­
erate at excessive speeds. An absence of
the smooth start-up function or speed con­
trol indicates that the electronics are faul­
ty.
9.1 Sawing along the scribe mark
The cut indicators display the cutting sequence
without a guide rail:
0° cuts: [7-1]
45° cuts: [7-2]
7
45°
0°
7-1
7-2
9.2 Cutting sections
Position the saw with the front part of the saw
table on the workpiece, switch on saw and push
forward in cutting direction.
9.3 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must be observed without fail when
plunge cutting:
– Always position saw with the rear edge of
the saw table against a fixed stop.
– When working with the guide rail, place the
saw against the kickback stop FS-RSP (ac­
cessories) [8-6] clamped to the guide rail.
CAUTION
Danger of crushing
► Always keep a firm grip on the machine
with your free hand when adjusting plunge
cuts.
► Never position your fingers behind or be­
low the saw blade.
English
15