Festool CSC SYS 50 EBI, Оригинальное руководство пользователя

Страница: 40 / 254

13 Accessories
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk .
14 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
Before disposal, users must remove discharged
batteries, accumulators that are not enclosed
by the device and lights that can be removed
from the old device without causing damage, if
these are present. The old batteries and re­
chargeable batteries can then be recycled sys­
tematically.
In accordance with the European Directive on
waste electrical and electronic equipment and
implementation in national law, used power
tools must be collected separately and handed
in for environmentally friendly recycling.
Information about collection points for correct
disposal is available at www.festool.co.uk/
recycling .
Information on REACH: www.festool.co.uk/
reach
15 General information
Imported into the UK by
Festool UK Ltd
1 Anglo Saxon Way
Bury St Edmunds
IP30 9XH
Great Britain
15.1 Bluetooth
®
The Bluetooth ® word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
15.2 Information on data privacy
The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en­
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
16 Troubleshooting
Problem Possible causes Remedy
The display does not
come on.
One or both battery packs are
discharged.
Charge the battery packs.
Incorrect battery pack used. Use suitable battery packs (see section 4 ).
The display does not
show anything.
Display fault. Contact an authorised service workshop or the
manufacturer.
The display shows a
warning.
Warning, e.g. due to over­
heating.
Observe the info text in the dialogue box and ac­
knowledge the message via the focus line.
The display shows a
failure.
The power tool is attempting
to solve a problem, e.g. over­
heating.
Follow the instructions on the display.
The power tool is faulty. Contact an authorised service workshop or the
manufacturer.
Status LED flashes red. Incorrect battery pack combi­
nation inserted.
See Section 4 .
Undervoltage upon system
start (battery level too low).
Replace the battery pack.
The Systainer hood
does not close.
Accessory parts are not in the
parked position.
Move the power tool to the transport position
(see Section 11.1 ).
English
40