Supplemental Owner’s Manual
7
Setup
This section describes the basic setup of a new CMS OF
router table system and the optional accessories that may
be added to the table. Operation-specific setup and configu-
rations are described in the “
Operation
” section beginning
on page
20.
Caution!
Throughout this section, neither the
router nor the router table should be connected to
electrical power.
Setting up the GE Base.
The GE base can be used with the legs folded or extended.
However, for initial router table setup, it will be easier to
have the legs extended.
1. Turn the GE base on its side or upside down on the floor.
2.
Loosen the 4 clamping knobs on the legs.
3.
Open the legs, and retighten the clamping knobs.
4.
Stand the base up on it legs.
Clamping
Knob
GE Base
Setting up the VL Base.
The VL model base has 2 legs, and is intended to connect
to the edge of an MFT/3 multi-function table.
1. Turn the VL base on its side or upside down on the floor.
2.
Loosen the 2 clamping knobs on the legs.
3.
Open the legs, and retighten the clamping knobs.
Clamping
Knob
VL Base
4. Using the provided 5mm hex key, loosen the 2 clamps.
5. Align the V-pads with the channel on the MFT/3 and tilt
the VL base up to slide it into the channel. Before lower-
ing the VL base back down, make sure the clamps are
not binding on the channel.
6. Tighten the 2 clamps.
V-Pad
Hex Key
Clamp
