ferrotec Genius II, Быстрый старт

Страница: 3 / 28

Genius II Quick Start Guide i 01010-9031-0, Rev. B
Table of Contents
Page
Section Number and Title Number
1 Genius II Quick Start Guide ........................................................................ 1
1.1 Contents of Genius II Kits ............................................................................. 1
1.2 Basic Hardware Installation ........................................................................... 1
1.3 Making Cable Connections ............................................................................. 2
1.4 Connecting the AC Power Cable and Powering Up the Genius II ...................... 9
1.5 Configuring the Control Modules .................................................................. 10
List of Illustrations
Page
Figure Number and Title Number
Figure 1 Genius II Front Panel, Showing Connections Port for Hand Held Remote Controller .................... 1
Figure 2 Connectors on Genius II Rear Panel ......................................................................................... 2
Figure 3 Genius II Cabling Diagram ...................................................................................................... 4
Figure 4 Connections To Be Made via Rear Panel Connector X110 .......................................................... 6
Figure 5 Sample Circuit Supplying BEAM ON and BEAM OFF Inputs via X110 Pins 5 and 6 ........................ 7
Figure 6 Connections to Rear Panel Connector X119, Configuration #1 ................................................... 8
Figure 7 Connections to Rear Panel Connector X119, Configuration #2 ................................................... 8
Figure 8 Genius II Input Power Cable Receptacle and Rear Panel On/Off Switch ...................................... 9
Figure 9 Genius II Start Screen ........................................................................................................... 10
Figure 10 Config>Main Screen After Initial Boot-Up ............................................................................... 10
Figure 11 Configuration>Main Screen After User Configures All Control Modules as Remote I/O ............... 11
Figure 12 Configuration E-Beam Screen After Initial Boot-Up .................................................................. 11
Figure 13 Config>Turret Screen at Initial Boot-Up ................................................................................. 12
Figure 14 Config>Turret Screen After User Alters Rotation, Seek Speed, and Index Speed ....................... 13
Figure 15 Config>Turret Screen After Turret Configuration Procedure is Completed ................................ 14
Figure 16 Config>Sweep Screen, Beam Position Limits Unconfigured, Initial State ................................... 14
Figure 17 Config>Sweep Screen, Beam Position Limits Unconfigured, Beam Switched On ........................ 15
Figure 18 Remote Controller in Config Mode with Menu 1 Selected and Beam on at 5%, ......................... 16
Figure 19 Remote Controller, Beam On @ 5%, Config Mode, Menu 1 and
Pos Adjust
Selected ................. 17
Figure 20 Remote Controller in Config Mode with Menu 2 Selected, User Setting the -Lat Position Limit .... 18
Figure 21 Config>Sweep Screen After All Four Limits Are Set ................................................................. 19
Figure 22 Config>Sweep Screen, Configuration Completed, Auxiliary Menu Displayed .............................. 20
Figure 23 User Exiting Configuration Mode, Mode Select Popup Displayed ............................................... 20
List of Tables
Page
Table Number and Title Number
Table 1 Functional Descriptions of Pins on Rear Panel Connector X110 ...................................................... 7
Table 2 Functional Descriptions of Pins on Rear Panel Connector X119 ...................................................... 9