16
INSTALLATION
MASTER-SLAVE configuration
A setting must be made to the units to establish which one is to be assigned the MASTER function and which are the
SLAVES . Do not assign two units belonging to the same group as the MASTER function .
Configuration is done through the series of microswitches on the control board indicated by the message DIPA-S1
A different address can also be associated with each Slave
unit; this will allow a specific setting to be assigned for
each different unit possibly through the MASTER unit . This
option is only possible with the use of the wall-mounted
control available as an accessory .
For the settings to be made to the first six DIPA-S1 series
DIP switches, refer to the table opposite .
Fig . 7
