MT Owners Manual
24
9
REPLACING PARTS
Before carrying out any work, it is mandatory to:
•
Lower the shredder to the ground
•
Disconnect the power takeoff, stop the tractor and take out the starting key.
•
Wear working gloves.
9.1
Flail replacement:
When the flails are worn, they must all be
replaced. In case of a partially broken flail, it is
advisable to replace the broken one and the
one diametrically opposite, in order to maintain
the balance (See Figure 43).
9.2
Belt replacement:
•
Remove the beltguard (1).
•
Loosen the nut (2) and the screw (2), remove the belts and replace them.
•
After replacing the belts proceed in reverse order (see 5.2 Figure 33).
9.3
Pipes Replacement:
•
Before working on the hydraulic system, bleed all pressure, working with the
engine stopped and using all control levers.
•
Pay particular attention to cleanliness as dirt and dust can cause considerable
damage to the hydraulic system.
•
Replace any damaged pipes with genuine spare parts or with others of the same
specification; ensure that they are not kinked or twisted, remembering to check this
throughout the entire cycle of arm movement.
10
DEMOLITION, DIFFERENTIATED DIVISION OF THE MATERIALS AND DISPOSAL
If the machine is in need of disposal, all its parts that might be dangerous to the
enviroment have to be made safe. The materials on the machine that have to
undergo a differentiated division are:
•
steel
•
mineral oil
•
rubber
•
plastic
•
electric system conductors
All the above modification operations and the final disposal have to be carried out in
total respect of the present provisions of law on the subject.
Figure 43
