1. Place the toothed washers
16
on the fixtures
22
.
Use the toothed washer
16
with the letter "R" for the right side and the one
with the letter "L" for the left side.
Make sure that the triangular markings of the toothed washers are positioned in
line with the three line markings on the fixtures.
2. Place one rod
7
on each toothed washer.
Make sure that the plastic cogs of the toothed washer reach into the holes in the
rods.
Make sure that the bends of the rods point inwards.
3. Guide the adjusting screws
17
through the boreholes of the rods and toothed
washers into the fixtures and tighten them clockwise.
Both rods are attached.
4. Push the strain relief
12
onto the connecting tube
6
.
5. Align the connecting tube with the rods so that the bore holes are on top of each
other.
6. Push two screws
3
through the bore holes so that the heads point inwards
and the threads outwards.
7. Place a washer
4
on each screw.
8. Twist one quick release
5
clockwise onto each screw.
9. Twist the quick releases onto the thread until they are at a distance of approx. 5
mm from the rod.
10.Fold up the quick releases so that they fit flush on the connecting tube.
11. Align the handlebar
2
with the connecting tube so that the bore holes are on
top of each other.
12.Connect the handlebar with the connecting tube by also installing two screws,
nuts and quick releases here.
13.Fix the power cable
23
with the two cable clamps
8
to the handlebar.
The handlebar is attached.
Before first use
15
Содержание GLS36K
Страница 2: ...2 2 1 4 3 5 6 7 9 10 11 8 12 13 14 15 16 17 ...
Страница 12: ... Never operate the device with faulty safety devices covers or without safety devices Safety 12 ...
Страница 14: ...Attaching the handlebar 1 2 22 3 4 5 12 6 23 8 7 17 16 Before first use 14 ...
Страница 16: ...Operation Controls A 18 22 19 23 21 20 24 25 Operation 16 ...
