FERREX 25CC, Руководство пользователя

Страница: 25 / 54

Kapitelüberschrift
29
Operation
Please note that the statutory regulations governing noise abatement may differ
from one location to another.
Each time before use, check the following:
-
That there are no leaks in the fuel system.
-
That the equipment is in perfect condition and that the safety devices and
cutting devices are complete.
-
That all screws are securely fastened.
-
That the claw stop (Fig. 1/pos. 21) is securely fastened. If you need to tighten it,
use the allen wrench (Fig. 1/pos. 22).
-
That all moving parts move smoothly.
Starting the engine when cold
Make sure, that the fuel tank is filled with the relevant mixture of petrol and also
top up the chain oil.
1.
Activate the hand guard / Chain Brake Lever before starting (Fig. 6/pos 3).
2.
Switch the I/STOP-switch to ‘0’ (OFF) (Fig. 8 / pos 15).
3.
Pull the choke switch (14) fully out until it locks (Fig. 9/arrow direction 1).
4.
Push the fuel pump (4) 10 times (Fig. 1).
5.
Place the saw on a firm, flat surface. Hold the saw firmly. Pull the starter grip (8)
rapidly 2 times. Beware of moving chain!
6.
Push in the choke switch (14) as far as it will go (Fig. 9/arrow direction 2).
7.
Switch the I/STOP-switch to ‘I’ (ON) to start the machine (Fig. 8/ pos. 15).
8.
Hold the saw firmly and pull the starter grip (8) rapidly 4 times. Engine should
start.
m
CAUTION
Never allow the starter grip (8) to snap back when it has been pulled out.
This may result in damage.
Operation