Fermax VDS, Техническое руководство

Страница: 25 / 44

VDS VDS
VDS VDS
VDS VDS VDS
VDS VDS
VDS
Page 25 Code 97508I-1 V07_09
Programming the lock-release code on Direct Panels
All Direct panel models allow the lock-release times to be programmed.
* There are two programmable activation times:
- Door opening time from the residence and from the panel keypad (using the opening code).
- Opening time corresponding to button located inside the building which serves to activate the lock-release function
(providing it has been installed).
* The programming sequence is as follows:
1.- Disconnect the power supply and then reconnect. A time frame of approximately 1 minute exists for the
execution of the following sequence.
2.- Enter the programming code 3 1 4 1 followed by 4 digits and press the % key.
Of these 4 figures, the first two correspond to the opening time set from the residence and the last two to the
opening time set from the button installed in the entrance hall.
NOTES:
- The possible times range between 1 and 99 seconds.
- Any time less than 10 seconds must be preceded by the digit ‘0’.
- In the case of an error during time programming (or if you wish to make any modifications) you must re-start the
sequence from step 1.
NOTES:
- Use key ‘A’ to delete or re-start the sequence.
- Do not forget to disengage the short circuit between «Bs» and «-» on the panel amplifier after carrying out the
necessary tasks.
- Once the opening code has been activated, this function cannot be disabled. This means that an opening code will
All Direct panel models enable the door to be opened from the outdoor entry panel by entering a 4-digit code.
The steps to be followed to activate and configure the door lock release using a code are detailed below:
* Door lock-release activation sequence.
1.- With the power supply disconnected, execute a short circuit between the « Bs » and « - » amplifier terminals
(negative) (or press the opening button if it is installed).
2.- Maintaining the short-circuit induced above, connect the system’s power supply (at this point it will no longer be
necessary to maintain the short circuit or hold down the button). You will have a time frame of 1 minute to activate
the opening code as is described in the following point.
3.- Enter the programming code 3 1 4 1 (this code cannot be changed) and enter the four digit code you wish to use
to open the door, followed by the
key.
* Changing the code
In order to be able to change the opening code, you must know the previous digit combination used. If the previous
code is not known, the sequence described above cannot be carried out.
The code changing programming sequence is the following:
1.- Enter the programming code: 3 1 4 1.
2.- Enter the current door opening code.
3.- Enter the new code (four digits) and press the key.
Programming the door lock-release time on Direct Panels