Fermax STAND-ALONE CONTROLLER 1 DOOR WG, Руководство по установке

Страница: 16 / 52

Cod. 97864b V09_19
6
Change PIN
Programming Step Keystroke Combination
Note: Below is done outside programming mode, users can undertake this themselves
1. Change the card associated PIN
(There will auto associate PIN (8888)
to cards when adding card users) * (Read Card) (Old PIN) # (New PIN) #
(Repeat New PIN) # *
(PIN: 4~6 digits)
1. Change the users' PIN
* (ID Number) # (Old PIN) # (New PIN) #
(Repeat New PIN) # *
(PIN: 4~6 digits)
Example: - Code 9876 ID=1: *1 #9876#New PIN#New PIN#*
-Code 6543 ID=5: *5 #6543# New PIN # New PIN #*
Delete User Card(s) or PIN(s) by Remote Control
Programming Step Keystroke Combination
1. Enter Program Mode * (Master Code) #
2. Delete User By User ID
OR
2. Delete User – By Card
OR
2. Delete User – By Card number
OR
2. Delete User – By PIN
OR
2. Delete All User
2 (User ID) #
2 (Read Card on External Reader) #
2 (Input last 8 digits Card number) #
2 (Input PIN) #
2 (Mater Code) #
3. Exit Program Mode *
Controller programming
BY REMOTE CONTROL
Note:
⚫
Remote Control: Please use the Infrared Remote Control to program the controller. The
“IR” on the controller is the infrared receiving window, please direct the Remote Control to
it.
Set Relay Configuration
The relay configuration sets the behavior of the output relay on activation.
Programming Step Keystroke Combination
1. Enter Program Mode * (Master Code) #
2. Pulse Mode
OR
2. Toggle Mode
3 (1~99) #
The relay time is 2~99 seconds. (1 is 50mS)
(Factory default is 5 seconds)
3 0 #
Sets the relay to ON/OFF Toggle mode
3. Exit Program Mode *