Fermax STAND-ALONE CONTROLLER 1 DOOR WG, Руководство по установке

Страница: 14 / 52

Cod. 97864b V09_19
4
Programming
Master Cards Programming
-Power off.
-Press the Exit Button
(or connect “OPEN” and “GND”to be short circuit), hold it .
-Power on, there will be two beeps, and the LED light turns into orange.
-Release the exit button (o
r disconnect “OPEN” and “GND”).
-Then read any two cards on the external reader (the type of the Master Cards is according to the external reader. For
example: the external reader is 125KHz HID Reader, then the Master Cards must be 125KHz HID cards.)
Of the two cards reading, the 1 one is Master Add Card, the 2 one is the Master Delete Card.
Programming users
Programming will vary depending on access confirguration. Follow the instructions according to your access
configuration.
BY MASTER CARDS
Notes:
⚫
User ID number: Assign a user ID to the access card in order to track it. The common
user ID number can be any number fom 0~999. IMPORTANT: User IDs do not have to be proceeded with any
leading zeros. Recording of User ID is crical. Modifications to the
user require the User ID be available.
⚫
PIN: Can be any 4~6 digits except 8888 which is reserved.
For the users: after entering the code confirm with dash (Eg: 9876#)
Add Users by Master Add Card
Add card users
Master Add Card – Read User Card – Master Add Card (Cards can be added continuously)
Add PIN users
Master Add Card – Input PIN + # – Master Add Card (PINs can be added continuously)
Delete Users by Master Delete Card
Delete card users
Master Delete Card – Read Card – Master Delete Card (Cards can be deleted continuously)
Delete PIN users
Master Delete Card – Input PIN + # – Master Delete Card (PINs can be deleted continuously)