Ferm WSM1008, Оригинальное руководство пользователя

Страница: 7 / 128

7
EN
Kickback
Kickback is the upward and backward movement
of the cutting discs when the cutting discs
unexpectedly touch an object. Securely hold the
machine with both hands during use. Keep your
attention focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or
materials with the rotating cutting discs;
- blunt cutting discs;
- cutting discs that are not properly mounted;
- cutting into a previous cut;
- a lack of attention to the operation;
- an instable stance.
Additional safety warnings for lasers
● Do not look directly into the laser beam.
● Do not point the laser beam humans or
animals.
● Do not point the laser beam at strongly
reflecting material.
● Do not insert hard objects into the laser optics.
● Clean the laser optics with a soft,
dry brush.
● Only have the laser repaired by a qualified
technician.
Electrical safety
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
● Do not use the machine if the mains cable or
the mains plug is damaged.
● Only use extension cables that are suitable for
the power rating of the machine with a
minimum thickness of 1.5 mm
2
. If you use a
extension cable reel, always fully unroll the
cable.
Mains plug replacement (UK only)
If the moulded 3-pin plug attached to the unit is
damaged and needs replacing, it is important that it
is correctly destroyed and replaced by an
approved BS 1363/13A fused plug and that the
following wiring instructions are followed.
The wires in the mains cable are coloured in
accordance with the following code:
blue neutral
brown live
As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
- The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured black.
- The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured red.
TECHNICAL DATA
WSM1008
Mains voltage V~ 230
Mains frequency Hz 50
Power input W 1,600
No-load speed min
-1
6,000
Slot width mm 8 - 30
Slot depth mm 8 - 40
Cutting disc
Diameter
mm 150
Bore mm 22.2
Protection class IP 20
Weight kg 6.8
NOISE AND VIBRATION
WSM1008
Sound pressure (Lpa) dB(A) 98.8
Acoustic power (Lwa) dB(A) 109,8
Uncertainty (K) dB(A) 3
Vibration (main grip) m/s
2
3.74
Vibration (auxiliary grip) m/s
2
3.50
Uncertainty (K) m/s
2
1.5
Wear hearing protection.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardised test given in EN 60745; it may be used
to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level