BEFORE USING THE SAW
Ensure the saw is unplugged from mains before
making adjustments, mounting accesories or chan-
ging blades.
CHANGING/FITTING SAW BLADES
Refer to illustration below
-
Depress the spindle lock lever (6) and keep it pressed,
then use the 13mm box spanner (2) provided to turn
the blade-retaining bolt anticlockwise.
-
Remove the bolt, washer and blade if fitted. Make sure
the flange is present on the shaft and is the right way up.
-
Open the blade guard with lever (1) and replace or fit
the saw blade with the teeth facing the same way as the
riving knife (4) - the teeth face towards the front of saw.
-
Fit the washer and bolt (clockwise) hand tight.
-
Depress the spindle lock lever and keeping it pressed,
tighten the bolt securely with the box spanner.
-
Check that the blade guard is free to revolve and that
the blade does not touch any part of the casing or guard.
-
After fitting a new blade it may be necessary to adjust
the riving knife.
ADJUSTING THE RIVING KNIFE
Refer to illustration below.
-
Use a suitable screwdriver (not supplied) to loosen
both screws (2)
-
Rotate Blade guard with lever (1) and keep open while
adjusting the riving knife. Refer to the illustration for
minimum and maximum distances.
-
Tighten both screws securely.
-
Check that the riving knife is in the correct position and
is in line with the blade.
-
Release the blade guard.
MOUNTING THE PARALLEL GUIDE
Referring to the illustration below.
-
Loosen thumbscrew (1)
-
Slide the parallel guide (2) into slots with the fence
facing downwards.
-
Set guide to the required position
-
Tighten thumbscrew.
ADJUSTING THE CUTTING ANGLE
Referring to the illustration below.
-
Loosen (anticlockwise) the thumbscrew (1) on the
angle quadrant and the locking lever (rotate anti-
clockwise) located at the rear of blade.
-
Set the shoe to the desired angle 0-45 degrees.
-
The cutting angle is indicated by the pointer (3)
-
Securely tighten the thumbscrew and the locking lever.
ADJUSTING THE DEPTH OF CUT
Referring to the illustration below.
-
Loosen locking lever (1) anticlockwise.
-
Move the shoe (2) downwards to required depth
marked on quadrant (3)
-
Securely tighten locking lever clockwise.
1 2
3
1
3
2
45
30
0
1
2
80
A=45
B=90
max 5 mm
max 5 m
m
3
2
1
1
4 3 5
2
4
Ferm Ferm
9
