English
Learning Function
The learning function is used to extend the pre-programmed codes. The standard code list
already provides you with the most important functions, but it is possible to add a few
additional functions. A fully functional original remote control is required for learning
programming.
Please use fresh batteries for both the Learning Remote Control and the Original Remote
Control.
1. Press down and hold the
device
button which you want to learn (e.g. TV) and press
find
(blue) button at the same time. When LED turns on release them both.
2. Point the IR transmitter of the original remote control remotes face to the IR receiver of
your RCU660 remote by approximately 30 mm apart. Keep two remotes at the same
straight line to make the learning process more accurate.
3. Press and release the target button on your RCU660 remote control which you want to
learn (e.g. “rec”), the LED starts to flash.
4. Press the one button (e.g. “rec”) from your original remote control, when you see LED
on new universal remote control flashes three times and stop, it means RCU660 has
accepted new code and now you can start to learn another new code from original
remote.
5. Repeat step 3 to 4 to learn another code from original remote control.
6. Press the device button (e.g. TV) to save the learned code and exit learning mode.
Note
:
•
When you can’t choose any more RCU660 buttons for learning, it means that remote
memory is full (RCU660 has limit for total 60 buttons).
•
The learning mode is automatically terminated if no entry occurs during 14 seconds
period.