English
Installation of batteries
Remove the cover of the battery compartment on the
rear panel of the remote control unit; slide it downwards
and put it aside. Insert two AAA (R03) batteries into the
compartment, observing the indicated polarity.
Do not
mix old and new batteries, or batteries of different
types.
Replace the battery compartment cover. Slide it
upwards until it locks in place.
Note
:
•
If the LED’s become dim please replace the batteries.
To make your remote control ready for use, you need to carry out one of the following
steps:
Set up device via auto search
1. Switch on the device that you like to control.
2. Point the remote control at your device. Press and hold down the
device
button (e.g.
TV) for 5 seconds. The LED turns on and after a moment LED start flashing, that means
RCU660 is in auto search mode and you can release
device
button.
3. Now the “VOL+” or “POWER” signal is automatically transmitted from the remote control
to the device (code scan). As soon as the volume of the device (e.g. TV) changes or
device turns off, immediately press the
device
key to stop the Automatic Search .
4. Check the function of the other buttons on the remote control. If none of the buttons
function (i.e. the search was not be stopped in time) or the majority of the buttons do not
function correctly, restart the search (see steps 2 to 4) to find a suitable code. If the
majority of the buttons function correctly, set- up has been successful. Re-press the
device
button (e.g. TV) to save the code and to terminate the set-up mode.
Note
:
•
Entering the auto searching mode, it will search forward from the current code.
•
Sometimes, remote control does not work properly just because auto search was not
stopped in time. In this case, just enter into manual search again, and press
Vol–
button
approx. every 1.5 seconds to search backward the code database.
•
If you are not satisfied with certain buttons assignments, or some functions are missing,
then you can use additionally learning function.