English
Setup device via brand name code
1. Switch on the device that you like to control.
2. The list is available on the website ferguson-digital.eu
3. Find the code number of your device brand in the code list from the relevant device
group.
4. Press and hold the
device
button (e.g. AUX) for three seconds. Release the device
button as soon as LED lights up, now it is in set up mode.
5. Enter the 4-digit device code within 10 seconds. If an entry is not made within 10
seconds, the set- up mode is automatically terminated.
6. The LED turns off if the remote accepts the code. If the LED flashes three times, that
means the code may be wrong, and the remote control remains in set-up mode, enter
the correct code from the list again in good time.
7. Check the function of the buttons on remote control. If it does not function correctly, try
another 4-digit device code from the list under the same brand. Repeat steps 4 to 7 until
all the basic functions operate correctly.
8.
Exit the set-up mode by pressing the
device
button (this mode is also terminated if no
button is pressed for 10 seconds).
Setup device via manual search
1. Switch on the device that you like to control.
2. Point the remote control at the device. Press and hold down the
device
button (e.g. TV)
for 3 seconds. The LED lights up and the remote is in manual set-up mode, release the
device button now.
3. Press the
Vol+
button approx. every 1.5 seconds.
4. As soon as the volume of the device (e.g. TV) changes or the device turns off, check
whether the other buttons on the remote control function correctly. If the majority of the
buttons does not function correctly, press the
Vol+
approx. every 1.5 seconds to initiate
the reactive code (manual search is continued, see steps 3 to 4).
5. If the majority of the buttons on the remote control functions correctly, save the code by
pressing the
device
button (e.g. TV) to terminate the manual search.
Note
:
•
If you are not satisfied with certain buttons assignments or some functions are missing,
then you can use additionally learning function.
•
Sometimes remote control does not work properly just because manual search was not
stopped in time. In this case, just enter into manual search again, and press
Vol–
button
approx. every 1.5 seconds to search backward the code database.
•
The Manual Search is automatically terminated if no entry occurs during 30 seconds
period.
•
Manual search mode, search forward from the current code.