Ferax FVP-2000E, Оригинальное руководство пользователя

Страница: 32 / 60

Ferax 32
GB
• Keep the main lead always away from the
hot air stream and the mouth piece;
• Put the mains switch in position ‘I or II’ to
let your hot air gun operate:
“1” = 50 degrees, air flow 250-500 l/min.
“0” = Off
“2” = 50-650 degrees, air flow 250-500 l/
min.
On the steps II and III, the temperature at the
nozzle outlet can the continuously regulated.
After displaying the target temperature, the
actual temperature (e.g. 100° C) at the nozzle
outlet is shown with blinking
4 3
until the
selected target temperature is reached. The
arrows
4 3
then disappear and the display
shows the actual temperature.
The target temperature can be increased in
steps of 10° C by pressing the “+” side of the
temperature button or reduced pressing the
“-”. Brief pressing of the button increases or
decreases the target temperature one time by
10° C. When the temperature is excess 650° C,
the heats switches it off automatically, however,
the heater continues to run. When the heater
has cooled to operating temperature, the heater
is switched on again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all
appliances on a little part of the workpiece.
Use of accessoires
Fig. B
Deflector nozzle (4)
Deflects air away from glass for example when
stripping paint in window frames or softening
putty.
Scraper nozzle (5)
This is used to scrape and strip paint.
Air reducer nozzle (6)
Use this when intensified heat is needed in a
specific area. Like corners and small spaces.
Fishtail nozzle (7)
Distributes air equally over small areas
Paint scraper (8)
Use this tool to scrape paint.
4. MAINTENANCE
Always disconnect the apparatus
before carrying out inspection or
cleaning. Never use water or other
liquids to clean the electrical parts of
the hot air gun.
• Never use easy inflammable liquids for
cleaning the hot air gun, especially for the
mouthpiece.
• Regular maintenance of your hot air gun
prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to
prevent overheating.
Troubleshooting
In case the hot air gun does not work well, we
give you subjoined some possible causes and
their solutions.
• The engine gets overheated.
• The ventilation slots of the hot air gun are
dirty.
• Clean the ventilation slots.
• The hot air gun does not start when it is
switched on.
• Interruption in the electrical circuit.
• Check the mains lead and the mains
plug.
• The switch is defective.
• Pull the mains lead out of the wall
socket, because there is a chance of fire
risk ! Have the hot air gun repaired at
your local dealer.
• The engine does not work, but it does
heat.
• Interruption in the electrical circuit.
• Pull the mains lead out of the wall
socket, because there is a chance of fire
risk ! Have the hot air gun repaired at
your local dealer.
Faults
Should a fault occur, e.g. after wear of a part,
please contact your reseller. On the separately
enclosed spare parts list you can find an
overview of the parts that can be ordered.
Environment
To prevent damage during transport, the